Test Automation:

• Design system/software level test cases
• Document the test cases in Software Lifecycle Management tool
• Implement test cases in EXAM test automation tool
• Execute the test suite for various Software releases
• Analysis and report generation
• Failed test cases are discussed with respective project leads and problem reports are created for the bugs found.

Hardware-Software Interface (HSI) testing:

• All the interfaces to the microcontroller are verified as per the functional specification

Functions:

• Inductive position sensors
• Active and passive speed sensors
• Output Power stages (Digital out and PWM out)
• Digital inputs (PWM in and Switch in)
• Analog inputs Supporting functions like EEPROM
• Watchdog controller

• Literature research on calculation of copper losses in Switched Reluctance Machines (SRM)
• Build and extend MATLAB/Simulink tools for copper loss calculation in SRM
• Execution of coupled simulations (MATLAB/Simulink and FEM)
• Executing electromagnetic FE simulations
• Build machine models in Finite Element Method Magnetics (FEMM)
• Implementing and testing of FPGA based control strategy on SRM test bench

Plant modeling:

• Project specific customer requirements gathering and analysis, for model adaptation
• a) Model adaptation by updating of sensor and actuator curves, CAN frames compilation, configuring the model bus
  signals to the respective HiL I/O- hardware channels based on wiring harness design
  b) Online model calibration of Fuel system, Engine, Air system (Intake and Exhaust), and Drive train to bring actuator and governor levels in closed loop
• Calibrated HiL models are subjected to overnight FTP-75 drive cycle test to ensure no failures due to the model are
  registered in the ECU diagnostic error memory
• Models are then delivered to the internal test team for full system level test and failure reaction tests. Calibrated HiL
  models are subjected to overnight FTP-75 drive cycle test to ensure no failures due to the model are registered in the ECU diagnostic error memory
• Extension of HiL model support during the testing phase and supporting in debugging the failures found

Other activities:

• Validating the HiL models developed within the team and supporting in debugging the failures
• Providing on-time HiL- support for project teams in setting up the HiL and ensuring closed loop of required modules being verified for functional testing
• Training newly joined team members.
• HiL booking management (6 HiL systems) for various projects
• Ensuring clean and safe working area

• Instrumentation of various sensors at desired locations on the gearbox under test
• NI- LabVIEW based measurement and control of test system
• Testing the gearbox as per the test specification at various flight loads
• Result analysis and reporting